gauge block

The working performance of the probe has been testified by measuring the flatness and thickness of a standard gauge block and the diameter of a convex lens.

通过对标准量块的平面度、厚度以及一个有效直径约为6mm的凸透镜的测量，验证了探头的有效性。

互联网摘选

Finally, this paper collects all technique links of above vision measurements together. Under laboratory conditions, gauge block size and axial size between prefabricated camshafts are measured respectively to test measurement accuracy of vision measurement structure size.

最后，本文将上述视觉测量的各个技术环节集成在一起，在实验室条件下，分别测量量块的尺寸和装配式凸轮轴凸轮间的轴向尺寸，以检验视觉测量结构件尺寸的测量精度。

互联网摘选

Ability to use Callipers, Micrometers , Gauges, Profile Projector, Gauge Block.

能使用测径规, 千分尺, 测量仪表,轮廓测定投影器, 块规.

互联网摘选

In the laboratory simulated environment, we measure the gauge block and analyze measurement results. Experimental data show that each module of the system meets design requirements, stable and reliable.

在实验室模拟环境中对量块进行测量，对测量结果进行分析，试验数据显示此系统中各模块均满足设计要求，工作稳定可靠。

互联网摘选

Error of indication of comparator was calibrated by using gauge block with conjugate method.

比较法测量量块的仪器的示值误差是采用配对法用量块校准的.

互联网摘选

Collecting and processing module is designed based on MCU, which is used to acquire small signals, measure gauge block temperature, control the automatic positioning of the two-dimensional moving platform and communicate with the computer. 3.

设计以单片机为核心的信号采集和控制模块，该模块用于采集微小位移信号、测量量块表面温度，控制二维步进电机移动平台的自动定位，以及和计算机通讯。

互联网摘选

The paper gives an analysis on the source and size of measurement error of gauge block by relative measuring method.

分析了相对测量法量块测量过程中误差的来源和大小。

互联网摘选

The virtual grating phase shifting moire fringe method is studied to measure the parameters of gauge block which combines the techniques on grating, moire, and phase shifting interferometry.

研究了集光栅技术、莫尔技术、相移干涉术为一体的虚光栅移相莫尔条纹法测量量块的原理及关键技术。

互联网摘选

Analysis of Measurement Uncertainty for A Type of Contact Positioning Gauge Block Interferometer

接触定位式量块干涉仪测量不确定度的分析

互联网摘选

Effects of repeatability on uncertainty of measurement results adopted gauge block pairing method

重复性对量块配对法测量结果不确定度的影响

互联网摘选

By scanning the standard gauge block, the relative measurement error of the system was less than 0.25%.

对标准量块进行扫描实验得到系统的相对测量误差小于0.25%。

互联网摘选